HAZARD WARNING SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER (for Manual Air Conditioning System) |
![]() |
for Manual Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 10 claws and 4 clips.
![]() |
Detach the 4 claws and disconnect the air conditioner control.
Disconnect the connectors and remove the center instrument cluster finish panel.
![]() |
for Automatic Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER (for Automatic Air Conditioning System) |
![]() |
for Manual Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 10 claws and 4 clips.
![]() |
Detach the 4 claws and disconnect the air conditioner control.
Disconnect the connectors and remove the center instrument cluster finish panel.
![]() |
for Automatic Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.
| *1 | Protective Tape |
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 4. REMOVE HEATER CONTROL KNOB (for Manual Air Conditioning System) |
![]() |
Remove the No. 2 heater control knob as shown in the illustration.
| 5. REMOVE FRE/REC CONTROL KNOB (for Manual Air Conditioning System) |
![]() |
Remove the heater control knob as shown in the illustration.
| 6. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Detach the 2 claws and remove the switch.