Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


B278367E01


  1. for Manual Air Conditioning System:

    1. Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 10 claws and 4 clips.



    3. B278366
    4. Detach the 4 claws and disconnect the air conditioner control.

    5. Disconnect the connectors and remove the center instrument cluster finish panel.



    B278368E01
  1. for Automatic Air Conditioning System:

    1. Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 8 claws and 4 clips.

    3. Disconnect the connectors and remove the center instrument cluster finish panel.



3. REMOVE HEATER CONTROL KNOB (for Manual Air Conditioning System)


E225816
  1. Remove the No. 2 heater control knob as shown in the illustration.



4. REMOVE FRE/REC CONTROL KNOB (for Manual Air Conditioning System)


E225816
  1. Remove the No. 2 heater control knob as shown in the illustration.



5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for Manual Air Conditioning System)


B113570E01
  1. Detach the 2 claws and remove the switch.