FRONT DOOR SPEAKER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
![]() |
Detach the 2 clips and remove the front door lower frame bracket garnish.
| *A | w/o Front No. 2 Speaker |
| *B | w/ Front No. 2 Speaker |
| 4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Remove the screw and speaker.
| 5. REMOVE DOOR PULL HANDLE |
![]() |
Remove the screw and door pull handle.
| 6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL |
![]() |
Using a moulding remover, detach the 2 clips and 4 claws.
Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.
| 7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the clip and screw.
Detach the 8 clips and remove the front door trim board.
| *1 | Clip |
| *2 | Screw |
| 8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Put a 5 mm (0.197 in.) drill bit into a drill.
Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.
| Area | Specified Condition |
| A | 4 mm (0.157 in.) |
Lightly press the drill against the 3 rivets, drill off the flanges of the 3 rivets and remove the front No. 1 speaker assembly.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.