Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER

REAR DOOR SPEAKER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR SPEAKER ASSEMBLY
  1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.



    E225840
  1. Using an air riveter or hand riveter, install the speaker with 3 new rivets.

    NOTICE:

    1. B171664E19
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
      Text in Illustration 
      *1
      Mandrel
      *2
      Riveter
      *a
      INCORRECT
      *b
      CORRECT

    2. B172390E19
      Confirm that the rivets are seated properly against the speaker.
      Text in Illustration 
      *1
      Riveter
      *a
      INCORRECT
      *b
      CORRECT
    3. Do not tilt the riveter when installing the rivet to the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B172391E17
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.
      Text in Illustration 
      *1
      Riveter
      *a
      INCORRECT
      *b
      CORRECT

  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B281150
  1. Connect the rear door inside locking cable and rear door lock remote control cable to the rear door inside handle.

  1. Attach the 2 guides as indicated by the arrow in the illustration, and then attach the claw to install the rear door inside handle.



3. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
  1. Connect the connector.

  1. Attach the 2 claws and 2 clips to install the rear power window regulator switch assembly with rear door armrest base panel.



4. INSTALL DOOR PULL HANDLE
  1. Install the door pull handle with the screw.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).