INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT NO. 1 INTEGRATION RELAY (MAIN) |
Check the EFI fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI fuse | Always | Below 1 Ω |
Check the MAIN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1J-1 - 1J-4 | Battery voltage not applied to terminals 1J-2 and 1J-3 | 10 kΩ or higher |
| Battery voltage applied to terminals 1J-2 and 1J-3 | Below 1 Ω |
| *a | Component without harness connected (Integration Relay) |
| 2. REMOVE NO. 1 INTEGRATION RELAY (EDU) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1J-5 - 1J-8 | Battery voltage not applied to terminals 1J-6 and 1J-7 | 10 kΩ or higher |
| Battery voltage applied to terminals 1J-6 and 1J-7 | Below 1 Ω |
| *a | Component without harness connected (Integration Relay) |