POWER OUTLET SOCKET > REMOVAL |
| 1. REMOVE SWITCH BASE |
![]() |
Detach the 9 claws and guide.
Disconnect the connectors and remove the switch base.
| 2. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY |
![]() |
Rotate the socket to disengage the power outlet socket cover's notch from the socket's hole.
Pull out the socket halfway.
Align the socket with the cover's grooves and remove the socket.
| 3. REMOVE BACK DOOR SCUFF PLATE |
![]() |
Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.
| 4. REMOVE REAR DOOR SCUFF PLATE LH |
![]() |
Put protective tape around the rear door scuff plate.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and 2 clips and remove the rear door scuff plate.
| 5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Remove the rear door opening trim weatherstrip.
| 6. REMOVE QUARTER TRIM HOOK |
![]() |
Remove the screw and quarter trim hook.
| 7. REMOVE QUARTER INSIDE TRIM BOARD LH |
![]() |
Detach the 2 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
w/ Rear No. 2 Seat:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Using a clip remover, remove the clip.
Detach the 7 claws and 10 clips.
Disconnect the power point socket connector and remove the quarter inside trim board.

| 8. REMOVE REAR NO. 1 POWER OUTLET SOCKET ASSEMBLY |
![]() |
Detach the 2 claw fittings and remove the socket.