Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ACCELERATOR PEDAL POSITION SENSOR
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

  1. Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.
    If the result is not as specified, refer to DTC P2120 (Click here).