Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR (w/o Glow Plug Controller)

INTAKE AIR TEMPERATURE SENSOR (w/o Glow Plug Controller) > INSTALLATION

for Preparation Click here



1. INSTALL INTAKE AIR TEMPERATURE SENSOR
  1. Using a 22 mm deep socket wrench, install a new gasket and the intake air temperature sensor.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Connect the intake air temperature sensor connector.



2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Install the engine cover with the 3 bolts and 2 cap nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }