Home › ENGINE · 1KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR (w/ Glow Plug Controller)

INTAKE AIR TEMPERATURE SENSOR (w/ Glow Plug Controller) > INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR TEMPERATURE SENSOR


    A221977E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.21 to 2.65 kΩ

    Text in Illustration 
    *1
    Resistance kΩ
    *2
    Temperature °C(°F)
    *3
    Acceptable Range
    *a
    Component without harness connected
    (Intake Air Temperature Sensor)

    NOTICE:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

    If the result is not as specified, replace the intake air temperature sensor.