CYLINDER HEAD > REPAIR |
| 1. REPAIR INTAKE VALVE SEAT |
![]() |
If the seating is too high on the valve face, use 25 and 45° cutters to correct the seat.
| *a | 1.2 to 1.6 mm (0.0472 to 0.0630 in.) |
![]() |
If the seating is too low on the valve face, use 70 and 45° cutters to correct the seat.
| *a | 1.2 to 1.6 mm (0.0472 to 0.0630 in.) |
Hand-lap the valve and valve seat with an abrasive compound.
Clean the valve and valve seat.
| 2. REPAIR EXHAUST VALVE SEAT |
![]() |
If the seating is too high on the valve face, use 25 and 45° cutters to correct the seat.
| *a | 1.6 to 2.0 mm (0.0630 to 0.0787 in.) |
![]() |
If the seating is too low on the valve face, use 75 and 45° cutters to correct the seat.
| *a | 1.6 to 2.0 mm (0.0630 to 0.0787 in.) |
Hand-lap the valve and valve seat with an abrasive compound.
Clean the valve and valve seat.