Home › ENGINE · 2KD-FTV › FUEL › FUEL FILTER

FUEL FILTER > INSPECTION

for Preparation Click here



1. INSPECT FUEL FILTER ASSEMBLY


    A098950E02
  1. Inspect the level warning switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Float at upper end position
      Below 1 Ω
      1 - 2
      Float at lower end position
      10 kΩ or higher

      If the result is not as specified, replace the fuel filter assembly.

  1. Inspect the clogging switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      Below 1 Ω

      If the result is not as specified, replace the fuel filter assembly.