Home › ENGINE ยท 2TR-FBE › ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > REPAIR

for Preparation Click here



1. REPAIR INTAKE VALVE SEAT

NOTICE:
Keep the lip free from foreign matter.



    A099449E01
  1. Apply a light coat of Prussian blue (or white lead) to the valve face.

  1. Lightly press the valve face against the valve seat.

  1. Check the valve seat according to the following procedures.

    1. If blue appears 360° around the valve face, the valve face is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and valve face are concentric. If not, resurface the valve seat.

    3. Check that the valve seat contact is in the middle of the valve face with the width between 1.0 to 1.4 mm (0.0394 to 0.0551 in.).



    A099450E01
  1. If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.



    A099451E01
  1. If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.

  1. Hand-lap the valve and valve seat with an abrasive compound.

  1. Check the valve seating position.



2. REPAIR EXHAUST VALVE SEAT

NOTICE:
Keep the lip free from foreign matter.



    A099449E01
  1. Apply a light coat of Prussian blue (or white lead) to the valve face.

  1. Lightly press the valve face against the valve seat.

  1. Check the valve seat according to the following procedures.

    1. If blue appears 360° around the valve face, the valve face is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and valve face are concentric. If not, resurface the valve seat.

    3. Check that the valve seat contact is in the middle of the valve face with the width between 1.0 to 1.4 mm (0.0394 to 0.0551 in.).



    A099450E01
  1. If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.



    A099451E01
  1. If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.

  1. Hand-lab the valve and valve seat with an abrasive compound.

  1. Check the valve seating position.



3. BORE CYLINDER

HINT:
  1. Bore all the 4 cylinders for the O/S piston outside diameter.
  2. Replace all the piston rings with ones to match the O/S pistons.



    A097953E04
  1. Keep 4 new O/S pistons.

    O/S 0.50 piston diameter:
    95.440 to 95.466 mm (3.7575 to 3.7585 in.)

  1. Using a micrometer, measure the piston diameter at right angles to the piston center line, the indicated distance from the piston end.

    Standard distance:
    13.8 mm (0.543 in.)

  1. Calculate how much each cylinder needs to be rebored:

    Size to be rebored = P + C - H:
    P = Piston diameter
    C = Piston clearance: 0.024 to 0.063 mm (0.000945 to 0.00248 in.)
    H = Allowance for honing: 0.02 mm (0.000787 in.) or less

  1. Bore and hone the cylinders to calculated dimensions.

    Maximum honing:
    0.02 mm (0.000787 in.)

    NOTICE:
    Excess honing will destroy the finished roundness.