Home › ENGINE · 2TR-FBE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


  1. Check the resistance.



      A112088E12
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (HT1B) - 2 (+B)
      20°C (68°F)
      11 to 16 Ω
      1 (HT1B) - 4 (E2)
      Always
      10 kΩ or higher

      If the result is not as specified, replace the heated oxygen sensor.