Home › ENGINE ยท 1KD-FTV › INTAKE › INTERCOOLER (w/o Glow Plug Controller)

INTERCOOLER (w/o Glow Plug Controller) > INSTALLATION

for Preparation Click here



1. INSTALL INTERCOOLER ASSEMBLY
  1. Install a new gasket and the intake air connector with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. w/ EGR Cooler:
    Install the intercooler with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    A110367E01
  1. w/o EGR Cooler:
    Install the intercooler with the 4 bolts.

    Torque:
    for bolt A:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }
    for bolt B:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Install a new No. 2 air hose and then tighten the 2 hose clamps.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }

  1. Tighten the 2 hose clamps of the No. 1 air hose.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }



2. INSTALL INTAKE AIR TEMPERATURE SENSOR
  1. Using a 22 mm deep socket wrench, install a new gasket and the intake air temperature sensor.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Connect the intake air temperature sensor connector.



3. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. w/ EGR Cooler:

    1. Install the manifold absolute pressure sensor with the 2 bolts.

      Torque:
      6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    2. Connect the vacuum hose.

    3. Attach the 2 clamps and connect the manifold absolute pressure sensor connector.

  1. w/o EGR Cooler:

    1. Install the manifold absolute pressure sensor with the bolt.

      Torque:
      6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    2. Connect the vacuum hose and manifold absolute pressure sensor connector.

    3. Install the gas filter with the bolt.

      Torque:
      6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Install the engine cover with the 3 bolts and 2 cap nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }