Home › ENGINE ยท 1KD-FTV › INTAKE › INTERCOOLER (w/o Glow Plug Controller)

INTERCOOLER (w/o Glow Plug Controller) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A211905E01
  1. Remove the 3 bolts, 2 cap nuts and No. 1 engine cover.



2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


  1. w/ EGR Cooler:



      A211889
    1. Detach the 2 clamps and disconnect the manifold absolute pressure sensor connector.

    2. Disconnect the vacuum hose.

    3. Remove the 2 bolts and manifold absolute pressure sensor.



  1. w/o EGR Cooler:



      A110363
    1. Remove the bolt and disconnect the gas filter.



    2. A110364
    3. Disconnect the manifold absolute pressure sensor connector and vacuum hose.

    4. Remove the bolt and manifold absolute pressure sensor.



3. REMOVE INTAKE AIR TEMPERATURE SENSOR


    A264767E01
  1. Disconnect the intake air temperature sensor connector.

  1. Using a 22 mm deep socket wrench, remove the intake air temperature sensor.

    HINT:
    Replace the intake air temperature sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the intake air temperature sensor each time the intercooler is replaced.



4. REMOVE INTERCOOLER ASSEMBLY


    A264095E01
  1. Loosen the 2 hose clamps of the No. 1 air hose.



    A110366
  1. Loosen the 2 hose clamps of the No. 2 air hose.



    A264096E01
  1. Remove the 4 bolts and intercooler.



    A264089E01
  1. Remove the 4 bolts, intake air connector and gasket.