Home › ENGINE ยท 1KD-FTV › INTAKE › INTERCOOLER (w/ Glow Plug Controller)

INTERCOOLER (w/ Glow Plug Controller) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A254063
  1. Remove the 3 bolts, 2 cap nuts and No. 1 engine cover.
    Text in Illustration 
    V100136
    Cap Nut



2. REMOVE INTAKE AIR TEMPERATURE SENSOR
  1. Disconnect the intake air temperature sensor connector.



    A272519
  1. Using a 22 mm deep socket wrench, remove the intake air temperature sensor.

    HINT:
    Replace the intake air temperature sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the intake air temperature sensor each time the intercooler is replaced.



3. REMOVE INTERCOOLER ASSEMBLY


    A253488
  1. Loosen the 2 hose clamps of the No. 1 air hose.



    A253489
  1. Loosen the 2 hose clamps of the No. 2 air hose.



    A253490
  1. Remove the 4 bolts and intercooler.



    A254052
  1. Remove the 4 bolts, intake air connector and gasket.