CAMSHAFT (for Bank 2) > INSPECTION |
| 1. INSPECT CAMSHAFT |
![]() |
Inspect the camshaft for runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
![]() |
Inspect the cam lobes.
Using a micrometer, measure the cam lobe height.
| Camshaft | Specified Condition |
| Intake | 44.168 to 44.268 mm (1.7389 to 1.7428 in.) |
| Exhaust | 44.580 to 44.680 mm (1.7551 to 1.7591 in.) |
| Camshaft | Specified Condition |
| Intake | 44.018 mm (1.7330 in.) |
| Exhaust | 44.430 mm (1.7492 in.) |
![]() |
Inspect the camshaft journals.
Using a micrometer, measure the journal diameter.
| Journal | Specified Condition |
| No. 1 journal | 35.971 to 35.985 mm (1.4162 to 1.4167 in.) |
| Other journal | 22.959 to 22.975 mm (0.9039 to 0.9045 in.) |
| 2. INSPECT CAMSHAFT TIMING GEAR |
Fix the intake camshaft with a vise.
![]() |
Align the knock pin hole in the camshaft timing gear with the knock pin of the camshaft, and install the camshaft timing gear with the bolt.
Confirm that the camshaft timing gear is locked.
![]() |
Release the lock pin.
Cover the 4 oil paths of the cam journal with vinyl tape as shown in the illustration.
Break through the tape of the advance side path and the retard side path on the opposite side of the groove.
![]() |
Using air guns, apply air pressure of approximately 200 kPa (2.0 kgf/cm2, 28 psi) into the 2 broken paths (advance side path and retard side path).
![]() |
Confirm if the camshaft timing gear rotates in the timing advance direction when weakening the air pressure of the timing retard path.
When the camshaft timing gear comes to the most advanced position, remove the air gun from the retard side path, and then remove the air gun from the advance side path.
Check the smooth revolution.
Except the position where the lock pin meets at the most retarded angle, let the camshaft timing gear turn back and forth. Check the movable range and that there is no disturbance.
Check the lock in the most retarded position.
Confirm that the camshaft timing gear is locked at the most retarded position.
![]() |
Remove the set bolt and camshaft timing gear.