Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH


    B281274
  1. Using a moulding remover, detach the 2 clips and 4 claws.

  1. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.



2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (for Front Passenger Side)


    B283864
  1. Using a moulding remover, detach the 2 clips and 4 claws.

  1. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.



3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B277018E01
  1. Detach the 2 clips and remove the front door lower frame bracket garnish.
    Text in Illustration 
    *A
    w/o Front No. 2 Speaker
    *B
    w/ Front No. 2 Speaker



4. REMOVE DOOR PULL HANDLE


    B277022
  1. Remove the screw and door pull handle.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B277024E01
  1. Remove the clip and screw.

  1. Detach the 8 clips and remove the front door trim board.
    Text in Illustration 
    *1
    Clip
    *2
    Screw



6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


B113822
  1. Disconnect the mirror connector.

  1. Remove the 3 nuts.

  1. Push down the claw and remove the outer rear view mirror assembly LH.



7. REMOVE OUTER MIRROR LH


  1. Using a screwdriver, detach the 2 claws as shown in the illustration.


    B278386E01


    Text in Illustration 
    *1
    Screwdriver
    *2
    Protective Tape

    NOTICE:
    Do not pull the outer mirror LH with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

    HINT:
    Apply protective tape to the mirror body and screwdriver tip.



    B278387
  1. Detach the 2 claws at the upper part of the outer mirror.

  1. Remove the outer mirror LH.



8. REMOVE OUTER MIRROR COVER LH


    B278447E01
  1. Remove the tape.
    Text in Illustration 
    *1
    Tape



    B278379
  1. Remove the screw, detach the 5 claws and remove the rubber base.

    HINT:
    It is not necessary to completely remove the rubber base. Slightly move the rubber base so that the outer mirror cover LH can be removed in a later step.



    B278380
  1. Using a T25 "TORX" socket wrench, remove the 3 screws.



    B278381
  1. Using a T25 "TORX" socket wrench, remove the screw.



    B278382
  1. Remove the 3 screws.



  1. Detach the 6 claws.


    B278383E01

  1. Detach the 2 claws and remove the outer mirror cover LH as shown in the illustration.



9. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    E225351
  1. Remove the 2 screws.

  1. Disconnect the connector and side turn signal light assembly LH.