Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 1GR-FE)

COMPRESSOR (for 1GR-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


E174572
  1. Remove the screw and cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


E174573E01
  1. Clamp the cooler compressor in a vise between aluminum plates.

  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00260  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.



    I104018
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Detach the connector clamp.



    I104019
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.