Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 2KD-FTV)

COMPRESSOR (for 2KD-FTV) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


E171823
  1. Remove the screw and cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


    E171824E04

    1. Clamp the cooler compressor in a vise between aluminum plates.

    2. Connect the battery to the magnet clutch assembly as shown in the illustration to fix the hub and rotor in place.

    3. Wrap the drive belt around the rotor and securely hold it in place by hand.

    4. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      HINT:
      There is no set number of magnet clutch washers since they are used for adjusting.

      Text in Illustration 
      *1
      Battery



    E155202
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Detach the connector clamp.



    E155203
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.