Home › TRANSMISSION · A340F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > A/T P Indicator Circuit

for Preparation Click here


DESCRIPTION

The propeller shaft and wheels are free even when the transmission shift lever is on P, as long as the transfer shift lever is on N. The A/T P indicator illuminates to warn the driver that the propeller shaft and wheels are not locked.
If the A/T P indicator illuminates, the transfer shift lever should be moved from N.

WIRING DIAGRAM


C246461E02


INSPECTION PROCEDURE

1.INSPECT PARK/NEUTRAL POSITION SWITCH


    G026080E17
  1. Disconnect the N1 park/neutral position switch connector.

  1. Measure the resistance of the park/neutral position switch when the shift lever is moved to each position.

    Standard resistance:
    Tester Connection
    Specified Condition
    2 (RB) - 6 (PL)
    Below 1 Ω
    2 (RB) - 6 (PL)
    10 kΩ or higher



NG
REPLACE PARK/NEUTRAL POSITION SWITCH
OK


2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
A110992E03
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the A/T P indicator light.

    1. Disconnect the T6 switch connector.

    2. Turn the ignition switch ON.

    3. Connect the T6-1 terminal of the wire harness side connector to the body ground, and then check the A/T P indicator light illuminates.

      OK:
      A/T P indicator light illuminates.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR