Home › TRANSMISSION · A343F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > A/T P Indicator Circuit

for Preparation Click here


DESCRIPTION

The propeller shaft and wheels are free even when the transmission shift lever is in P, as long as the transfer shift lever is in N. The A/T P indicator illuminates to warn the driver that the propeller shaft and wheels are not locked.
If the A/T P indicator illuminates, the transfer shift lever should be moved from N.

WIRING DIAGRAM


C175018E15


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)


    C237850E04
  1. Disconnect the T6 No. 2 Transfer Indicator Switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T6-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 2 Transfer Indicator Switch)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
C237864E01
  1. Remove the No. 2 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 Transfer Indicator Switch)
    *b
    Pushed
    *c
    Not pushed



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - ECM)
  1. Disconnect the T6 No. 2 Transfer Indicator Switch connector.

  1. Disconnect the E8 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T6-1 - E8-23 (TFN)
    Always
    Below 1 Ω
    T6-1 or E8-23 (TFN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM (Click here)