Home › TRANSMISSION · A340F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > TCM Power Source Circuit

for Preparation Click here


DESCRIPTION

When the ignition switch is turned ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM


C122129E01


INSPECTION PROCEDURE

1.CHECK TCM (IG2 VOLTAGE)
G039243E12
  1. Turn the ignition switch ON.

  1. Measure the voltage of the TCM connectors.

    Standard voltage:
    Tester Connection
    Specified Condition
    T35-6 (IG2) - T19-1 (E1)
    9 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK WIRE HARNESS (TCM - BODY GROUND)


    F045523E08
  1. Disconnect the T19 TCM connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T19-1 (E1)- Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.INSPECT FUSE (IGN)
A111770E01
  1. Remove the IGN fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


4.INSPECT IGNITION SWITCH


    A056879E04
  1. Disconnect the I8 ignition switch connector.

  1. Measure the resistance of the ignition switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    LOCK
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω



NG
REPLACE IGNITION SWITCH
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (BATTERY - IGNITION SWITCH, IGNITION SWITCH - TCM)