AUTOMATIC TRANSMISSION SYSTEM > ECU Power Source Circuit |

| 1.INSPECT IGNITION SWITCH |
![]() |
Disconnect the I8 ignition switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (AM2) - 6 (IG2) | LOCK | 10 kΩ or higher |
| 5 (AM2) - 6 (IG2) | ON | Below 1 Ω |
| *a | Component without harness connected (Ignition switch) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND) |
![]() |
Disconnect the T19 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T19-1 (E1) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to TCM) |
|
| ||||
| OK | |
| 3.CHECK TCM (TCM - BATTERY) |
Turn the ignition switch to ON.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T35-6 (IG2) - T19-1 (E1) | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||