DTC P0101 Mass or Volume Air Flow Circuit Range / Performance Problem |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| After warming up engine, idle engine for 20 seconds, and then maintain engine at 3000 rpm for 20 seconds | After the engine is warmed up, condition (a) continues for more than 10 seconds when idling (2 trip detection logic): (a) Mass air flow meter output is higher than 4.4 V. |
|
| Conditions (a) and (b) continue for more than 10 seconds with the engine speed at 1250 rpm or more (2 trip detection logic): (a) VTA is higher than 0.1 V. (b) Mass air flow meter output is below 0.7 V. |
| DTC No. | Data List |
| P0101 |
|
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0101 and other DTCs are output | A |
| P0101 is output | B |
|
| ||||
| B | |
| 2.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leakage .
|
| ||||
| OK | |
| 3.REPLACE MASS AIR FLOW METER |
Replace the mass air flow meter (Click here).
|
| ||||
| 4.REPAIR OR REPLACE AIR INDUCTION SYSTEM |
Repair or replace the air induction system.
| NEXT | |
| 5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
After warming up the engine, idle the engine for 20 seconds, and then maintain the engine at 3000 rpm for 20 seconds.
Confirm that the DTC is not output again.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input DTC P0101.
Check that STATUS is NORMAL. If STATUS is INCOMPLETE or N/A, maintain the engine at 3000 rpm for 30 seconds, and then idle the engine for 5 minutes.
| NEXT | ||
| ||