DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Condition (a) or (b) continues: (a) Significant decrease in battery voltage (b) Open in back-up power source circuit (1 trip detection logic) |
|

| 1.CHECK FUSE (EFI FUSE) |
![]() |
Remove the EFI fuse from the engine room junction block.
Measure the resistance of the EFI fuse.
|
| ||||
| OK | |
| 2.INSPECT ECM (BATT VOLTAGE) |
![]() |
Measure the voltage of the E5 and E6 ECM connectors.
| Tester Connection | Specified condition |
| BATT (E5-2) - E1 (E6-7) | 11 to 14 V |
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - EFI FUSE, EFI FUSE - BATTERY) |
![]() |
Check the harness and the connector between the EFI fuse and ECM.
Disconnect the E5 ECM connector.
Remove the EFI fuse from the engine room junction block.
Measure the resistance.
| Tester Connection | Specified Condition |
| BATT (E5-2) - EFI fuse (2) | Below 1 Ω |
| Tester Connection | Specified Condition |
| BATT (E5-2) or EFI fuse (2) - Body ground | 10 kΩ or higher |
Check the harness and the connector between the EFI fuse and battery.
Remove the EFI fuse from the engine room junction block.
Disconnect the positive battery terminal.
Measure the resistance.
| Tester Connection | Specified Condition |
| Battery positive terminal - EFI fuse (1) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Battery positive terminal or EFI fuse (1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | ||
| ||