DTC P0607 Control Module Performance |
DTC P1611 IC Circuit Malfunction |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 1 second | ECM internal error (1 trip detection logic) | ECM |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 1 second | ECM internal error (1 trip detection logic) | ECM |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0607 AND/OR P1611) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0607 or P1611 | A |
| P0607 or P1611 and other DTCs | B |
|
| ||||
| A | |
| 2.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||