DTC P0168 Fuel Temperature Too High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Drive vehicle at high speed or with heavy load (Use freeze frame data from time malfunction occurred as reference while driving) | All of following conditions are met (1 trip detection logic):
|
|
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0168) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0168 is output | A |
| P0168 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FUEL SUPPLY PUMP ASSEMBLY |
Perform a visual inspection of the exterior of the fuel supply pump assembly and check that there are no fuel leaks.
|
| ||||
| OK | |
| 3.CHECK FUEL SYSTEM |
Check if dirt is clogging the fuel cooler cooling fins. Clean the fins if they are clogged with dirt.
|
| ||||
| 4.REPLACE FUEL SUPPLY PUMP ASSEMBLY |
Replace the fuel supply pump assembly (Click here).
| NEXT | |
| 5.BLEED AIR FROM FUEL SYSTEM |
Bleed the air from the fuel system .
| NEXT | |
| 6.PERFORM FUEL SUPPLY PUMP INITIALIZATION |
Perform fuel supply pump initialization (Click here).
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON and turn the tester on.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / Fuel Temperature.
Drive the vehicle in a city area and check that the value of Fuel Temperature does not exceed 110°C (230°F).
| NEXT | ||
| ||