Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR (for DENSO Made)

GENERATOR (for DENSO Made) > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY


    A122149
  1. Place the drive end frame on the pulley.

  1. Install the rotor to the drive end frame.



2. INSTALL GENERATOR COIL ASSEMBLY


    A122150
  1. Place the generator washer on the rotor.



    A122151E01
  1. Using SST and a press, slowly press in the coil assembly.

    SST
    09285-76010  



    A196079
  1. Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A079315E06
  1. While pushing the 2 brushes inside the brush holder, insert a pin (diameter: 1.0 mm (0.039 in.)) into the brush holder hole.



    A196080E01
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.



4. INSTALL GENERATOR REAR END COVER


    A196077
  1. Install the terminal insulator to the generator coil.

    NOTICE:
    Pay attention to the mounting orientation of the terminal insulator.



    A122140
  1. Install the end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



5. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Temporarily install the generator pulley by hand.



    A203823E01
  1. Mount the generator in a vise between aluminum plate.

  1. Install SST to the pulley as shown in the illustration.

    SST
    09820-63021  



    A203825E01
  1. Using a wrench to Hold SST (A), turn SST (B) clockwise to tighten the pulley.

    Torque:
    without SST:
    111 N*m{ 1125 kgf*cm , 81 ft.*lbf }
    with SST:
    80 N*m{ 812 kgf*cm , 58 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 260 mm (10.24 in.)
    2. This torque value is effective when SST is parallel to a wrench.

  1. Check that the generator pulley rotates smoothly.



6. INSTALL GENERATOR PULLEY CAP


    A194780E01
  1. Install a new generator pulley cap.

    NOTICE:
    1. Align the cap guide of the generator pulley cap with the hole of the generator pulley and push it in by hand.
    2. Do not push in the generator pulley cap at an angle.