STARTER (for 2.0 kW Type) > DISASSEMBLY |
| 1. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Remove the nut and disconnect the lead wire from terminal C.
Remove the 2 through bolts.
Pull out the starter yoke together with the armature.
Remove the O-ring from the starter yoke.
| 2. REMOVE STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Remove the 2 screws and magnet starter switch assembly.
Remove the return spring.
![]() |
Remove the pinion gear, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.
| *1 | Pinion Gear |
| *2 | Idler Gear |
| *3 | Retainer |
| *4 | Clutch Roller |
| *5 | Return Spring |
| *6 | Starter Clutch Assembly |
| *7 | Starter Drive Housing |
![]() |
Using a magnet hand, remove the steel ball from the clutch shaft hole.
| *1 | Magnet Hand |
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and commutator end frame from the starter yoke.
Remove the O-ring from the starter yoke.
Disconnect the 4 starter yoke brushes from the starter brush holder.
![]() |
Using a screwdriver, pull back the spring.
Disconnect the brush from the starter brush holder.
Remove the starter brush holder from the starter yoke.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
Remove the starter armature from the starter yoke.