STARTER (for 2.7 kW Type) > REASSEMBLY |
| 1. INSTALL STARTER CLUTCH SUB-ASSEMBLY |
Apply high-temperature grease to the idler gear, steel ball, return spring, clutch roller and retainer.
![]() |
Install the steel ball.
Insert the return spring into the starter clutch hole.
![]() |
Install the starter clutch assembly, idler gear, retainer and clutch roller to the starter drive housing.
| *1 | Return Spring |
| *2 | Starter Clutch |
| *3 | Starter Drive Housing |
| *4 | Clutch Roller |
| *5 | Retainer |
| *6 | Idler Gear |
Install the starter drive housing to the magnet starter switch with the 3 screws.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Install the starter armature to the starter yoke.
| 3. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
Install the starter brush holder to the starter yoke.
Install the 4 starter brushes to the starter brush holder.
Using a screwdriver, pull back the spring.
Install the starter brush to the starter brush holder.
Install the commutator end frame with the 2 screws.
| 4. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the protrusion of the starter yoke with the groove of the magnet starter switch, and install the starter yoke and starter armature.
| *1 | Protrusion |
| *2 | Groove |
Install the 2 through bolts.
Connect the lead wire to terminal C with the nut.