DTC P0717 Input Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 |
|
|

| 1.CHECK SPEED SENSOR (NC0) (INSTALLATION) |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NC0) |
![]() |
Disconnect the T7 speed sensor connector from the transmission.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SPEED SENSOR (NC0) - ECM) |
![]() |
Disconnect the E22 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E22-5 (NC0+) - E22-10 (NC0-) | 20°C (68°F) | 560 to 680 Ω |
| E22-5 (NC0+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| E22-10 (NC0-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||