Home › TRANSMISSION · A343E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

DTC    P0717    Input Speed Sensor Circuit No Signal

for Preparation Click here


DESCRIPTION

The speed sensor (NC0) detects the rotation speed of the O/D input shaft from the rotation speed of the O/D direct clutch drum. Its construction is the same as that of the speed sensor (SP2).
By comparing the speed sensor (NC0) signal with the speed sensor (SP2) signal, the ECM detects the shift timing of the gears and controls the engine torque and hydraulic pressure according to various conditions. As a result, the gears shift smoothly.

DTC No.
DTC Detection Condition
Trouble Area
P0717
All conditions are met for 5 seconds or more (1-trip detection logic*1, 2-trip detection logic*2):
(a) Transmission input shaft speed is 300 rpm or less.
(b) Transmission output shaft speed is 500 rpm or more.
(c) Park/neutral position switch R input signal is off.
  1. Open or short in speed sensor (NC0) circuit
  2. Speed sensor (NC0)
  3. ECM
  1. *1: w/ OBD
  2. *2: w/o OBD

MONITOR DESCRIPTION

The input speed sensor (NC0) detects the transmission input shaft speed. The ECM determines the gear shift timing based on a comparison of the input speed sensor (NC0) (input shaft speed) with the output speed sensor (output shaft speed).
When the output shaft speed is higher than the expected value and the input shaft speed is 300 rpm or less while the vehicle is running with the shift lever on D, the ECM will conclude that there is a malfunction in the input speed sensor (NC0). The ECM will illuminate the MIL and set the DTC.

WIRING DIAGRAM


C155187E47


INSPECTION PROCEDURE

1.CHECK SPEED SENSOR (NC0) (INSTALLATION)


    C159067E02
  1. Check the speed sensor installation.

    OK:
    Installation bolt is tightened properly and there is no clearance between sensor and transmission case.



NG
SECURELY INSTALL SPEED SENSOR OR REPLACE SPEED SENSOR
OK


2.INSPECT SPEED SENSOR (NC0)
C159420E21
  1. Disconnect the T7 speed sensor connector from the transmission.



    C170570E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    560 to 680 Ω


    HINT:
    C192331E14
    Reference: Inspect using an oscilloscope.
    Check the waveform of the ECM connector.

    OK:
    Refer to illustration
    Item
    Content
    Tester Connection
    E10-34 (NC0+) - E10-26 (NC0-)
    Tool Setting
    5 V/DIV, 0.5 msec./DIV.
    Condition
    Engine is idling



NG
REPLACE SPEED SENSOR (NC0)
OK


3.CHECK WIRE HARNESS (SPEED SENSOR (NC0) - ECM)


    C192332E09
  1. Disconnect the E10 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-34 (NC0+) - E10-26 (NC0-)
    20°C (68°F)
    560 to 680 Ω
    E10-34 (NC0+) - Body ground
    20°C (68°F)
    10 kΩ or higher
    E10-26 (NC0-) - Body ground
    20°C (68°F)
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM