DTC P1601 Injector Correction Circuit Malfunction (EEPROM) |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 1 second | Any condition is met (1 trip detection logic):
|
|
| When replacing the ECM with a new one, input all learning values and codes into the new ECM as follows: |
Prior to replacing the ECM, use the intelligent tester to read and save each learning value and code from the original ECM (Click here).
After installing a new ECM, input the saved learning values and codes into the new ECM using the tester (Click here).
Turn the ignition switch off and turn the tester off.
Wait for at least 30 seconds.
Turn the ignition switch to ON and turn the tester on.
Clear the DTC P1601 stored in the ECM using the tester (Click here).
| Replacement Part | Utility Item |
| ECM |
|
| Injector assembly |
|
| 1.LEARNING VALUES CONFIRMATION |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Learning values confirmation .
| Result | Proceed to |
| The injector compensation codes are not input | A |
| The injector compensation codes registered in the ECM are different than the codes imprinted on the injector assemblies | A |
| The pilot quantity learning values are set to the default values | B |
| Except above | C |
|
| ||||
|
| ||||
| A | |
| 2.REGISTER INJECTOR COMPENSATION CODE |
Register the injector compensation code .
|
| ||||
| 3.LEARNING VALUES WRITE |
Install the old ECM.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Learning values save .
Remove the old ECM.
Install a new ECM.
Enter the following menus: Powertrain / Engine and ECT / Utility / Learning values write .
| NEXT | |
| 4.LEARNING VALUES CONFIRMATION |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Learning values confirmation .
| Result | Proceed to |
| The pilot quantity learning values are set to the default values | A |
| Except above | B |
|
| ||||
| A | |
| 5.PILOT QUANTITY LEARNING |
Perform the injector pilot quantity learning .
| NEXT | |
| 6.CHECK DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off and leave the vehicle for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| No DTC is output | A |
| P1601 is output | B |
|
| ||||
| A | ||
| ||
| 7.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off and leave the vehicle for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||