Home › BODY › MIRROR › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY


B207176E06
  1. Inspect the outer mirror switch.

    1. Select "L" on the select switch.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      4 (MLV) - 8 (B)
      6 (M+) - 7 (E)
      UP
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      4 (MLV) - 7 (E)
      6 (M+) - 8 (B)
      DOWN
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      5 (MLH) - 8 (B)
      6 (M+) - 7 (E)
      LEFT
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      5 (MLH) - 7 (E)
      6 (M+) - 8 (B)
      RIGHT
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher

      If the result is not as specified, replace the outer mirror switch assembly.

    3. Select "R" on the select switch.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (MRV) - 8 (B)
      6 (M+) - 7 (E)
      UP
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      3 (MRV) - 7 (E)
      6 (M+) - 8 (B)
      DOWN
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      2 (MRH) - 8 (B)
      6 (M+) - 7 (E)
      LEFT
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      2 (MRH) - 7 (E)
      6 (M+) - 8 (B)
      RIGHT
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher

      If the result is not as specified, replace the outer mirror switch assembly.

  1. Inspect the retract switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (E) - 10 (MF)
      8 (B) - 9 (MR)
      Pushed in
      Below 1 Ω
      7 (E) - 9 (MR)
      8 (B) - 10 (MF)
      Not pushed in
      Below 1 Ω

      If the result is not as specified, replace the outer mirror switch assembly.
      Text in Illustration 
      *1
      Retract Switch
      *2
      Select Switch
      *a
      Component without harness connected
      (Outer Mirror Switch Assembly)