Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

for Preparation Click here


DESCRIPTION


WIRING DIAGRAM


B062902E26


INSPECTION PROCEDURE

1.RESET POWER WINDOW REGULATOR MOTOR ASSEMBLY
  1. Reset the power window regulator motor.

  1. Check that the power window AUTO UP / DOWN function operates normally.

    OK:
    AUTO UP / DOWN function operates normally.



NG
Go to step 2
OK

END 

2.CHECK POWER WINDOW REGULATOR ASSEMBLY
  1. Remove the door glass.

  1. Operate the front door window regulator using the switch.

  1. Check that the power window regulator operates smoothly.

    OK:
    Power window regulator operates smoothly.



NG
REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
OK

REPLACE FRONT DOOR GLASS RUN RH