AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Heater Relay Circuit |

| 1.INSPECT NO. 1 HEATER RELAY |
![]() |
Remove the No. 1 heater relay from the driver side junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | Battery voltage is not applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher | |
| 3 - 4 | Battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NO. 1 HEATER RELAY - AIR CONDITIONING AMPLIFIER, BATTERY AND BODY GROUND) |
Remove the No. 1 heater relay from the driver side junction block assembly.
Disconnect the A44 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| No. 1 heater relay terminal 2 - A44-14 (HR) | Always | Below 1 Ω |
| No. 1 heater relay terminal 2 - Body ground | Always | 10 kΩ or higher |
| No. 1 heater relay terminal 3 - Body ground | Always | 10 kΩ or higher |
| No. 1 heater relay terminal 4 - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| No. 1 heater relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| No. 1 heater relay terminal 5 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A44-14 (HR) - Body ground |
| Below 1 V |
| Below 1 V | |
| 11 to 14 V |
| *a | Component with harness connected (Air Conditioning Amplifier Assembly) |
|
| ||||
| OK | ||
| ||