SFI SYSTEM (w/ Secondary Air Injection System) > VC Output Circuit |

| 1.CHECK MIL |
Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch ON.
|
| ||||
| NG | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Check the connection between the intelligent tester and ECM.
| Condition | Proceed to |
| Communication is possible | A |
| Communication is not possible | B |
|
| ||||
| B | |
| 3.INSPECT ECM (VC VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| E11-18 (VC) - E11-3 (E1) | Voltage is not 5 V |
| NEXT | |
| 4.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the T1 throttle body connector.
Turn the ignition switch ON.
Check the MIL.
| Condition | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
|
| ||||
| B | |
| 5.CHECK WIRE HARNESS (ECM - BODY GROUND) |
![]() |
Disconnect the T1 throttle body connector.
Disconnect the E11 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E11-18 (VC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||