POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Rear Power Window LH Manual Function does not Operate with Rear Power Window Switch LH |

| 1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (POWER SOURCE) |
![]() |
Disconnect the P12 regulator switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P12-3 - Body ground | Ignition switch ON | 10 to 14 V |
| P12-3 - Body ground | Ignition switch OFF | Below 1 V |
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Remove the switch.
Measure the resistance of the switch when the switch is operated.
| Tester Connection | Switch Condition | Specified Condition |
| 5 - 4 2 - 3 | UP | Below 1 Ω |
| 5 - 4 2 - 1 | OFF | Below 1 Ω |
| 5 - 3 2 - 1 | DOWN | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SWITCH - MOTOR) |

Disconnect the P12 switch connector.
Disconnect the P9 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P12-5 - P9-1 | Below 1 Ω |
| P12-2 - P9-2 | Below 1 Ω |
| P12-5 or P9-1 - Body ground | 10 kΩ or higher |
| P12-2 or P9-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY |
![]() |
Remove the motor.
Apply battery voltage to connector terminals 1 and 2.
Check that the motor gear rotates smoothly as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates clockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates counterclockwise |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MASTER SWITCH - REAR SWITCH LH) |

Disconnect the P6 master switch connector.
Disconnect the P12 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-12 (U) - P12-1 | Below 1 Ω |
| P6-10 (D) - P12-4 | Below 1 Ω |
| P6-12 (U) or P12-1 - Body ground | 10 kΩ or higher |
| P6-10 (D) or P12-4 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||