Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:
  1. It is only necessary to perform this procedure when replacing a No. 1 roof drip side finish moulding clip with a new one.
  2. If installing new No. 1 roof drip side finish moulding clips, remove the adhesive remaining where the No. 1 roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent.

HINT:
When installing a No. 1 roof drip side finish moulding clip, heat the vehicle body and clip using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
No. 1 Roof Drip Side Finish Moulding Clip
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or clip excessively.



    B187426E02
  1. Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new No. 1 roof drip side finish moulding clips.
    Text in Illustration 
    *1
    Adhesive
    *a
    2 to 3 mm Bead of Adhesive

    HINT:
    Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1991 psi) or more (when the temperature is 23°C (73°F))

  1. Apply primer to the body where the No. 1 roof drip side finish moulding clip will be installed.

    NOTICE:
    Do not let the primer dry.



  1. While using the position shown in the illustration as a reference, place the No. 1 roof drip side finish moulding clip onto the roof panel. Then position and install the clip after lightly pressing it so that the adhesive adheres to the primer.


    B277866E01


    Standard:

    Area
    Measurement (Reference Value)
    Area
    Measurement (Reference Value)
    A
    29.1 mm (1.15 in.)
    D
    30.4 mm (1.20 in.)
    B
    5.5 to 6.0 mm (0.217 to 0.236 in.)
    E
    5.4 to 5.9 mm (0.213 to 0.232 in.)
    C
    6.0 mm (0.236 in.)
    F
    6.7 mm (0.264 in.)

    NOTICE:
    Install the rear roof drip side finish moulding when 40 minutes or more have elapsed after pressing and installing the No. 1 roof drip side finish moulding clips.

    HINT:
    1. Initial hardening time: 40 minutes
    2. Complete hardening time: 48 hours



2. INSTALL ROOF DRIP SIDE FINISH MOULDING LH
  1. Attach the 2 clips to install the roof drip side finish moulding.