CLUTCH MASTER CYLINDER > INSTALLATION |
| 1. INSTALL CYLINDER PUSH ROD CLEVIS |
Install the lock nut and clevis to the push rod.
| 2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY |
Install a new gasket and the clutch master cylinder assembly with the 2 nuts.
Install the clutch pedal (Click here).
| 3. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench, connect the tube.
| 4. CONNECT CLUTCH RESERVOIR HOSE |
![]() |
Connect the clutch reservoir hose with the clip to the clutch master cylinder.
| 5. INSTALL COMBINATION METER ASSEMBLY |
| 6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.
| 7. BLEED AIR FROM CLUTCH PIPE LINE |
| 8. INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY |
Lift up the floor carpet to expose the asphalt sheet under the pedal.
![]() |
Check that the pedal height is correct.
w/o Clutch Switch:
Adjust the pedal height.
Loosen the lock nut and turn the stopper bolt until the pedal height is within the specified range.
Tighten the lock nut.
w/ Clutch Switch:
Adjust the pedal height.
Loosen the lock nut of stopper bolt and clutch switch. Then turn clutch switch backward.
Turn the stopper bolt until the pedal height is within the specified range.
Tighten the lock nut of stopper bolt.
Adjust the clutch switch assembly (Click here).
![]() |
Check the pedal free play and push rod play.
Depress the clutch pedal until resistance is felt.
Measure the distance between the pedal's released position and the position in the previous step.
Release the pedal. Using your finger, gently press the pedal until resistance increases slightly.
Measure the distance between the pedal's released position and the position in the previous step.
Adjust the pedal free play and push rod play.
Loosen the lock nut and turn the push rod until the pedal free play and push rod play are within the specified ranges.
Tighten the lock nut.
After adjusting the pedal free play and push rod play, check the pedal height.
![]() |
Check the clutch release point.
Pull the parking brake lever and use wheel chocks to stabilize the vehicle.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever to R until the gears contact.
Gently depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
| 9. CHECK FLUID LEVEL IN RESERVOIR |
| 10. CHECK FOR CLUTCH FLUID LEAKAGE |