Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. DISCONNECT REAR SPEED SENSOR LH (w/ ABS)



3. REMOVE TAILPIPE ASSEMBLY
  1. Remove the tail exhaust pipe for 2TR-FE .

  1. Remove the tail exhaust pipe for 1KD-FTV .

  1. Remove the tail exhaust pipe for 1GR-FE .

  1. Remove the tail exhaust pipe for 2TR-FBE (Click here).



4. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Disconnect No. 3 parking brake cable .



5. DISCONNECT REAR BRAKE TUBE FLEXIBLE HOSE


F049944E02
  1. Using a union nut wrench, disconnect the brake line from the flexible hose.

  1. Using a screwdriver, remove the clip.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the flexible hose from the 3 way joint.



6. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY


C118719
  1. Support the axle housing.

    1. Jack up and support the vehicle's frame on stands.

    2. Lower the axle housing until the coil spring tension is free, and maintain this position.

  1. Remove the nut and 2 retainers.



    C118720
  1. Remove the 2 bolts.

  1. Disconnect the shock absorber and 2 bushes from the axle housing and frame.

  1. Remove the lock nut, bracket, 3 retainers and 2 cushions.



7. REMOVE REAR COIL SPRING
  1. Slowly lower the rear axle housing.

    NOTICE:
    Be careful not to snap the brake line or parking brake cable.

  1. While lowering the axle housing, remove the coil spring and insulator.