Home › SUSPENSION & AXLE › SUSPENSION › REAR LOWER ARM

REAR LOWER ARM > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH
  1. Temporarily install the lower arm with the 2 bolts and 2 nut.



2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY



C237699E01


Text in Illustration 
*1
No. 3 Parking Brake Cable
*2
No. 3 Clip
  1. Install the No. 3 parking brake cable with the 4 bolts and nut.

    Torque:
    26 N*m{ 260 kgf*cm , 19 ft.*lbf }

  1. Install the No. 3 clip.

  1. Connect the No. 3 parking brake cable to the parking brake shoe lever LH and backing plate LH.

    1. Connect the No. 3 parking brake cable to the backing plate with the 2 bolts.

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    2. Connect the No. 3 parking brake cable to the parking brake shoe lever (Click here).



3. INSTALL REAR WHEEL

Torque:
105 N*m{ 1071 kgf*cm , 77 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several time to stabilize the suspension.



5. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
  1. Tighten the 2 bolts.

    Torque:
    145 N*m{ 1479 kgf*cm , 107 ft.*lbf }

    HINT:
    While fixing the nuts in place, tighten the bolts.