Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER MOTOR

REAR BLOWER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover.



2. REMOVE TONNEAU COVER HOLDER RH (w/ Tonneau Cover)

HINT:
Use the same procedure described for the LH side.



3. REMOVE TONNEAU COVER HANGER RH (w/ Tonneau Cover)

HINT:
Use the same procedure described for the LH side.



4. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)
(Click here)


5. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE BACK DOOR SCUFF PLATE


B276933
  1. Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.



8. REMOVE QUARTER TRIM HOOK


B276937

HINT:
Use the same procedure for both quarter trim hooks.

  1. Remove the screw and quarter trim hook.



9. REMOVE QUARTER INSIDE TRIM BOARD RH


B276928
  1. Detach the 2 claws and remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



    B277804
  1. Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.



    B277805
  1. w/ Rear No. 2 Seat:

    1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.

  1. Using a clip remover, remove the clip.



  1. Detach the 8 claws and 10 clips and remove the quarter inside trim board.


    B276941



10. REMOVE REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
  1. Disconnect the connector.



    E225823
  1. Remove the 3 screws and rear blower motor with fan sub-assembly.