REAR BLOWER MOTOR > REMOVAL |
| 1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Remove the tonneau cover.
| 2. REMOVE TONNEAU COVER HOLDER RH (w/ Tonneau Cover) |
| 3. REMOVE TONNEAU COVER HANGER RH (w/ Tonneau Cover) |
| 4. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat) |
| 5. REMOVE REAR DOOR SCUFF PLATE RH |
| 6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 7. REMOVE BACK DOOR SCUFF PLATE |
![]() |
Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.
| 8. REMOVE QUARTER TRIM HOOK |
![]() |
Remove the screw and quarter trim hook.
| 9. REMOVE QUARTER INSIDE TRIM BOARD RH |
![]() |
Detach the 2 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
w/ Rear No. 2 Seat:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Using a clip remover, remove the clip.
Detach the 8 claws and 10 clips and remove the quarter inside trim board.

| 10. REMOVE REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY |
Disconnect the connector.
![]() |
Remove the 3 screws and rear blower motor with fan sub-assembly.