Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK HEATER CONTROL ASSEMBLY (HAZARD WARNING SIGNAL SWITCH) (for Automatic Air Conditioning System)


B117617E01
  1. Remove the heater control assembly with the connectors connected.

  1. Measure the voltage of the connector.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A16 - 16 (SW1) - A16 - 1 (GND)
    Hazard warning signal switch OFF
    10 to 14 V
    A16 - 16 (SW1) - A16 - 1 (GND)
    Hazard warning signal switch ON
    Below 1 V

    If the result is not as specified, replace the control assembly.