Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY

PERSONAL LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


E224853E02
  1. Measure the resistance according to the value(s) in the table below.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    7 (B) - 10 (E)
    Spot light switch off
    10 kΩ or higher
    Spot light switch on
    Below 1 Ω
    7 (B) - 6 (CTY)
    Not door position
    10 kΩ or higher
    Door position
    Below 1 Ω

    If the result is not as specified, replace the map light assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Map Light Assembly)