REAR WIPER MOTOR > INSTALLATION |
| 1. INSTALL REAR WIPER MOTOR GROMMET |
![]() |
Apply MP grease to the entire inner surface of the wiper motor grommet.
| *1 | MP grease |
![]() |
Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.
| *1 | Position Mark |
| 2. INSTALL REAR WIPER MOTOR ASSEMBLY |
![]() |
Install the wiper motor with the 3 bolts.
Connect the connector.
| 3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.
![]() |
Clean the wiper pivot serrations with a wire brush.
| *1 | Wiper Arm Pivot Serrations |
| *2 | Wire Brush |
| *3 | Wiper Pivot Serrations |
![]() |
Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
| *1 | Ceramic Line |
Operate the rear wiper while spraying water or washer fluid on the glass. Make sure that there is no interference between the blade and pillar.
![]() |
Close the wiper arm head cap.
| 4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
Attach the 16 clips to install the back door trim board.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |