Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY (for HID Headlight)

HEADLIGHT ASSEMBLY (for HID Headlight) > REMOVAL

for Preparation Click here


CAUTION:
Make sure that the headlight control ECU sub-assembly LH is not connected or hot before removing the headlight control ECU sub-assembly.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE RADIATOR GRILLE
  1. Attach the 6 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.



4. REMOVE FOG LIGHT COVER LH


    B283429E01
  1. Put protective tape around the fog light cover.

  1. Using the screwdriver, detach the 8 claws and remove the fog light cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



5. REMOVE FOG LIGHT COVER RH

HINT:
Use the same procedure described for the LH side.



6. REMOVE FRONT BUMPER COVER


    B277936
  1. Remove the 6 screws and 3 clips.



    B277938E01
  1. Put protective tape around the front bumper cover.

  1. Remove the 2 screws, 2 bolts and 5 clips.
    Text in Illustration 
    *1
    Protective Tape



    B277939
  1. Detach the 8 claws and remove the front bumper cover.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose, and then drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.



7. REMOVE HEADLIGHT ASSEMBLY LH


    E225367E01
  1. Put protective tape around the headlight assembly LH.
    Text in Illustration 
    *1
    Protective tape

  1. Remove the 3 screws and bolt.

  1. Disconnect the connectors and remove the headlight assembly LH.