TRANSFER ASSEMBLY > INSPECTION |
| 1. INSPECT TRANSFER INPUT SHAFT |
![]() |
Using a micrometer, measure the diameter of the input shaft journal surface.
![]() |
Using a caliper gauge, measure the inside diameter of the input shaft bushing.
| 2. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance of the pinion gear.
| 3. INSPECT PLANETARY PINION GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the pinion gear.
| 4. INSPECT TRANSFER DRIVE SPROCKET THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance of the drive sprocket.
| 5. INSPECT TRANSFER DRIVE SPROCKET RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the drive sprocket.
| 6. INSPECT REAR TRANSFER OUTPUT SHAFT |
![]() |
Using a micrometer, measure the diameter of the output shaft journal surface.
| Position | Specified Condition |
| A | 27.98 to 27.99 mm (1.1016 to 1.1020 in.) |
| B | 31.98 to 32.00 mm (1.2591 to 1.2598 in.) |
| C | 34.98 to 35.00 mm (1.3772 to 1.3780 in.) |
| D | 36.98 to 37.00 mm (1.4559 to 1.4567 in.) |
| Position | Specified Condition |
| A | 27.98 mm (1.1016 in.) |
| B | 31.98 mm (1.2591 in.) |
| C | 34.98 mm (1.3772 in.) |
| D | 36.98 mm (1.4559 in.) |
| 7. INSPECT TRANSFER HIGH AND LOW CLUTCH SLEEVE AND NO. 2 TRANSFER GEAR SHIFT FORK CLEARANCE |
![]() |
Using a vernier caliper, measure the thickness of the No. 2 gear shift fork claw.
Using a vernier caliper, measure the groove of the high and low clutch sleeve.
Calculate the clearance between the high and low clutch sleeve and No. 2 gear shift fork.
| 8. INSPECT FRONT DRIVE CLUTCH SLEEVE AND CENTER DIFFERENTIAL LOCK FORK CLEARANCE |
![]() |
Using a vernier caliper, measure the thickness of the center differential lock fork claw.
Using a vernier caliper, measure the groove of the front drive clutch sleeve.
Calculate the clearance between the front drive clutch sleeve and center differential lock fork.
| 9. INSPECT CENTER DIFFERENTIAL CASE AND TRANSFER HIGH AND LOW CLUTCH SLEEVE |
![]() |
Check that the tip of the spline gear of the clutch sleeve is not worn.
Install the clutch sleeve to the differential case and check that the clutch sleeve moves smoothly.
If the results are not as specified, replace the differential case and clutch sleeve.
| 10. INSPECT CENTER DIFFERENTIAL CASE AND FRONT DRIVE CLUTCH SLEEVE |
![]() |
Check that the tip of the spline gear of the clutch sleeve is not worn.
Install the clutch sleeve to the differential case and check that the clutch sleeve moves smoothly.
If the results are not as specified, replace the differential case and clutch sleeve.